ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 2: Aileron Servo Installation Step 8Secure an 18-inch (457mm) servo extension to the servolead for the aileron. Make sure to secure the servo leadto the extension using string or a commercially availableconnector to prevent them from becoming disconnectedinside the wing. Step 10Use a drill and 1/16-inch (1.5mm) drill bit to drill fourholes, approximately 1/8-inch (3mm) from the corners ofthe servo cover. Step 9Tie the string that has been installed inside the wingto the servo extension. Use the string to pull the servoleads through the wing and to the opening of the wingpanel near the flap servo. You will pull the flap servo leadsand the throttle servo leads with this same pull string. Step 11Use four #2 x 3/8-inch sheet metal screws to secure theservo cover to the wing.16