ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 2: Aileron Servo InstallationRequired Parts• Assembled wing panel (right and left)• Servo w/hardware (2) • Control horn (2)• Pushrod connector (2) • Nylon clevis (2)• Servo mounting block (4)• 6-inch (152mm) pushrod wire (2)• 2-56 x 7/8-inch machine screw (6)• #2 x 3/8-inch sheet metal screw (8)• 1/4-inch (6mm) heat shrink tubing• 18-inch (457mm) servo extension (2)• 1 1 / 8x 1/4-inch (28mm x 6mm) dowel• 1 1 / 8x 5/16-inch (28mm x 8mm) dowel (2)Required Tools and Adhesives• Drill• Thin CA• Phillips screwdriver • Long servo arm• 30-minute epoxy• Hobby knife• Pencil• Felt-tipped pen• Drill bit: 1/16-inch (1.5mm), 5/32-inch (2mm) Step 1Remove the servo cover from the wing. Use a sharp hobbyknife to remove the covering from the opening in the coverso the servo arm can extend outside the cover. Step 2Position the aileron servo on the cover with the servo armcentered in the opening. Use a pencil to mark the coverwhere the flap servo is positioned. Step 3Use 30-minute epoxy to glue the servo mountingblocks to the servo cover. Allow the epoxy to fullycure before proceeding.14