ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 1: Hinging the Flaps and Ailerons Step 9Use medium grit sandpaper to sand the flaptorque rods. Use rubbing alcohol and a paper towelto remove any debris from the torque rod. This willaid in strengthening the bond between the flap torquerod and flap. Step 11Use medium grit sandpaper to sand the flaptorque rods. Use rubbing alcohol and a paper towelto remove any debris from the torque rod. This willaid in strengthening the bond between the flap torquerod and flap. Step 10Hinging the flaps follows the same procedure as theailerons, except you will need to apply 30-minute epoxy tothe torque rods that enter the flaps. Step 12Hinging the flaps follows the same procedure as theailerons, except you will need to apply 30-minute epoxy tothe torque rods that enter the flaps. Step 13Repeat Steps 1 though 12 for the remaining wing panel.13