ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 1: Hinging the Flaps and Ailerons Step 5Slide the aileron and outer flap into position on the wing.Make sure the inboard edge of the flap near the center ofthe wing, and the outer tip of the aileron near the wing tipdo not bind against the wing. Also make sure the flap andaileron do not bind against each other. Step 7After the CA has fully cured, gently pull on the wingand aileron to make sure the hinges are secure. If not,re-glue the hinges. Step 6Remove the T-pins from the hinge and push the ailerontight against the wing. Flex the aileron and apply enoughthin CA to fully penetrate the hinge. Apply CA to both thetop and bottom of the hinge. Step 8To break in the hinges, you will need to flex the aileron upand down a number of times.Important: Do not use accelerator whenhinging. The CA must be allowed to soakinto the hinge for the best possible bondbetween the hinge and surrounding wood.12