Pipet-Plus - Mettler Toledo

Example volumes for the 200 µL size are shown below.Volumes can be changed whether the piston is latched orunlatched. Volume ranges/ increments are shown below:Pipet-Plus Range (µL) SmallestVolume Adjustable Recommended Increment µL2 µL 0 to 2 0.1 to 2 0.00210 µL 0 to 10 0.5 to 10 0.0220 µL 0 to 20 2 to 20 0.02100 µL 0 to 100 10 to 100 0.2200 µL 0 to 200 20 to 200 0.2300 µL 0 to 300 20 to 300 0.51000 µL 0 to 1,000 100 to 1,000 2.02000 µL 0 to 2,000 200 to 2,000 2.05000 µL 0 to 5,000 500 to 5,000 5.010 mL 0 to 10 mL 1 mL to 10 mL 20.0FilterPipet-Plus 5000 µL and 10 mL pipettes use a filter in the endof the shaft to help prevent liquid entering the shaft and contaminatingthe piston, should the plunger snap up duringaspiration. Using such a filter is particularly important whenpipetting large volumes. Replace the filter if it gets wet.Figure 2 Filter OrientationFor 5000 µL pipettes insert the small diameter into the shaft,for 10 mL pipettes insert the large diameter into the shaft. Filterpart numbers are 6190-164 (pack of 100) and 6190-165 (pack of 1000).Tip Selection and MountingAlways use RAININ tips. Pipet-Plus pipettes are calibratedwith RAININ tips, and performance to published specificationscan only be guaranteed when RAININ tips are used.To mount a tip, press the Pipet-Plus shaft into the end of thetip with light force. RAININ tips will always seal properly onthe shaft with minimal force — do not use more force than isrequired.3