Cisco Small Business RV 120W Wireless-N VPN Firewall ...

Configuring the Wireless NetworkConfiguring Basic Wireless Settings3characters (or 26 hexadecimal characters) for 128-bit WEP. Valid hexadecimalcharacters are “0” to “9” and “A” to “F”.If you chose WPA Personal, WPA2 Personal, or WPA2 Personal Mixed:a. Enter the WPA Key, or password/phrase that will secure the network. Devicesconnecting to the network must use this phrase for authentication.b. If you want to see the password as you are entering it, check the UnmaskPassword box.c. In the Key Renewal field, enter the number of seconds after which the CiscoRV120W will generate a new key. These keys are internal keys exchangedbetween the Cisco RV120W and connected devices. The default value (3600seconds) is usually adequate unless you are experiencing network problems.If you chose WPA Enterprise or WPA2 Enterprise Mixed, no further configuration isrequired.If you chose WPA2 Enterprise, you can check the Pre-Authentication box(optional). Pre-authentication allows wireless clients to quickly switch betweenconnected wireless networks sharing the same security configuration. When awireless client disconnects from a wireless network, a notification is sent to thenetwork, which then sends the pre-authentication info to other wireless networks.STEP 8Click Save.Configuring MAC FilteringYou can use MAC filtering to permit or deny access to the wireless network basedon the MAC (hardware) address of the requesting device. For example, you canenter the MAC addresses of a set of PCs and only allow those PCs to access thenetwork. MAC filtering is configured for each wireless network.STEP 1STEP 2STEP 3STEP 4Choose Wireless > Basic Settings.In the Wireless Basic Settings Table, check the box on the left of the wirelessnetwork you want to configure.Click Edit MAC Filtering.Choose Enable.Cisco RV120W Administration Guide 58