Cisco Small Business RV 120W Wireless-N VPN Firewall ...

Configuring Virtual Private Networks (VPNs) and SecurityConfiguring a Basic VPN5Creating Cisco QuickVPN Client UsersTo use the Cisco QuickVPN, you must do the following:STEP 1 Enable remote management. See Configuring Remote Management, page 119.STEP 2Create QuickVPN users. See Configuring VPN Users, page 105. After a useraccount is created, the credentials can be used by the QuickVPN client.For more information on installing and using Cisco QuickVPN, see Appendix A,“Using Cisco QuickVPN for Windows 7, 2000, XP, or Vista.”Configuring a Basic VPNUse the basic VPN setup function to create a VPN with default values as proposedby the VPN Consortium (VPNC) and a Pre-shared Key (PSK). You can changethese values later if you need to further configure any VPN parameters.To configure a basic VPN:STEP 1STEP 2Choose VPN > IPsec > Basic VPN Setup.Choose to which peers the VPN tunnel will connect:• Gateway—Connects the Cisco RV120W to a gateway using a securetunnel.• VPN Client—Connects the Cisco RV120W to remote clients. The remoteclients must run VPN client software.STEP 3STEP 4STEP 5Enter a name for the connection. The connection name is used for management.Enter a pre-shared key. The VPN client or gateway will need to enter this key toestablish the VPN connection.Choose the type of address for the remote gateway, or the gateway to which theCisco RV120W will connect:• IP Address—Enter the IP address of the gateway in the field below.• FQDN (Fully-Qualified Domain Name)—Enter the domain name in the fieldbelow (for example, http://www.cisco.com).Cisco RV120W Administration Guide 93