SPE FREEZERS User Manual

Adjustment instructions3.5.2004 Rev. 1.06.1.3 Setting the SETPOINT1. To access the "Machine status" menu, press and immediately release the SET key.The label of the "Set" folder will appear;2. To display it, press SET again. The SETPOINT value will appear on the display.3. To change the SETPOINT value, use the arrow up and down keys within 15 seconds.6.1.4 Starting a manual defrost6.2 Changing the light bulbTo start a manual defrost cycle, press and hold down the arrow up key (P1) for 5 seconds.If the conditions required to start a defrost are not met (for example, evaporator sensortemperature is higher than defrost end temperature), the display will blink three times towarn the user that the operation will not be carried out.To change the light bulb perform the following steps (the voltage of the light bulb isshown on the adhesive label):• Switch off the appliance and disconnect the power cord;• Open the appliance door;• Remove the protective glass shield from the light;• Unscrew the light bulb located in the instrument panel and replace it with an identicalcomponent of the same voltage;• Refit the glass shield.6.3 Attaching and detaching the grille support guideCarry out the following steps to attach the grille support guides correctly:Push the guide downwards (2) and then inwards (3) in the chosen position of the rack.Pic. 6.3Perform the operation in reverse order to detach the guide.14