SPE FREEZERS User Manual

More documents

Recommendations

Info

Functional description3.5.2004 Rev. 1.03.2 Control panelThe following components are found on the appliance’s front panel:Pic. 3.1 - Front Panel1. Main switch2. Temperature display / Electronic controller6
Operating instructions3.5.2004 Rev. 1.04. Operating instructions4.1 Prior to use4.1.1 Preliminary checksGeneral checksTo ensure proper operation:• Check that the appliance is well levelled. If necessary, adjust the mobile part of theadjustable feet until the appliance is perfectly level.• Check that all plastic protective film has been removed from outer surfaces.• Check that the inside has been cleaned with warm water and neutral soap.• Check that the appliance is positioned as far from heat sources as possible.• Check for free, unobstructed air circulation inside motor compartment.• Check that locking keys (if available) are out of children’s reach.Checking the electrical equipment• Check that the power network voltage and frequency rating matches the valuesshown on the appliance’s rating plate (item 6 in paragraph "Rating plate data").• Check that the screws fixing the wires to the electric components found in theboard are properly tightened (as vibration could have worked them loose duringhandling and transportation).• Make sure that a 16A-fuse has been fitted upstream of the power socket (outlet).• Turn OFF the general switch to which the power cord plug will be connected.• Check that the power socket (outlet) is compatible with the type of plug the appliance has.If necessary, have the plug replaced with a suitable one by a professionally qualified technician,who will be in charge of checking that the gauge of socket (outlet) wires is suitablefor the appliance’s power input. Check that the plug is correctly plugged in.4.1.2 Start-up and checksOnce you have carried out all the above steps carefully, you are ready to start up the appliance:• Turn ON the general switch to which the power supply cord plug is connected.• Turn ON the appliance’s switch.• To change the SETPOINT, refer to paragraph "Thermostat operation" in chapter"Adjustment instructions".7
Page 4 and 5: 3.5.2004 Rev. 1.0
Page 6 and 7: 3.5.2004 Rev.5.7.3 Suggestions ....
Page 8 and 9: General information3.5.2004 Rev. 1.
Page 10 and 11: Safety3.5.2004 Rev. 1.02.2.1 Instal
Page 14 and 15: Operating instructions3.5.2004 Rev.
Page 16 and 17: Installation3.5.2004 Rev. 1.05. Ins
Page 18 and 19: Installation3.5.2004 Rev. 1.05.7 Co
Page 20 and 21: Adjustment instructions3.5.2004 Rev
Page 22: Troubleshooting3.5.2004 Rev. 1.016
Page 25: Technical specifications3.5.2004 Re
Page 30 and 31: Technical specifications3.5.2004 Re
Page 32: Technical specifications3.5.2004 Re

SPE FREEZERS User Manual

Create successful ePaper yourself

Delete template?

Save as template?