Cisco AP541N Dual-band Single-radio Access Point Administration ...

3Table 7 describes the fields to view or configure on the LAN Settings page.Table 7FieldLAN Settings Field DescriptionsDescriptionHostnameDNS name (host name) for the access point.The DNS name has the following requirements:• Maximum of 20 characters• Only letters, numbers and dashes. Double quote (") isnot a valid character.• Must start with a letter and end with either a letter or anumberMAC AddressManagementVLAN IDMAC address for the Ethernet port on this access point. Thisis a read-only field that you cannot change.Enter a number between 1 and 4094 for the managementVLAN ID used on your network.The default management VLAN ID is 1.Untagged VLANEnable or disable VLAN tagging. If you enable the untaggedVLAN, all traffic is tagged with a VLAN ID.By default all traffic on the access point uses VLAN 1, thedefault untagged VLAN. This means that all traffic isuntagged until you disable the untagged VLAN, change theuntagged traffic VLAN ID, or change the VLAN ID for a VAP orclient using RADIUS.Untagged VLANIDConnectionTypeProvide a number between 1 and 4094 for the untaggedVLAN ID. Traffic on the VLAN that you specify in this field isnot tagged with a VLAN ID.If you select DHCP, the access point acquires its IP address,subnet mask, DNS, and gateway information from a DHCPserver.If you select Static IP, you must enter information in the StaticIP Address, Subnet Mask, and Default Gateway fields.Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide 42