Cisco AP541N Dual-band Single-radio Access Point Administration ...

6AdministrationConfiguring the Web Server SettingsTable 33Web Server SettingsFieldHTTPS ServerStatusHTTP ServerStatusDescriptionEnable or disable access through a Secure HTTP Server(HTTPS). This setting is independent of the HTTP server statussetting.Enable or disable access through HTTP. This setting isindependent of the HTTPS server status setting.HTTP Port Specify the port number for HTTP traffic. (The default is 80.)MaximumSessionsSpecify the maximum number of HTTP and HTTPSconnections permitted to the access point Web server that areallowed at the same time. The permitted range is 1–10. Thenumber you enter affects the number of connections to theaccess point Configuration Utility. It has no impact on thenumber of wireless clients allowed to associate with theaccess point.Session Timeout Enter the number of minutes a HTTP or HTTPS session remainsidle before the session is terminated. The valid range is 1–1440minutes (24 hours).Generate SSLCertificateSelect this option to generate a new SSL certificate for thesecure Web server. This should be done once the access pointhas an IP address to ensure that the common name for thecertificate matches the IP address of the access point.Generating a new SSL certificate restarts the secure Webserver. The secure connection will not work until the newcertificate is accepted on the browser.NOTEClick Apply to apply the changes and to save the settings. If you disable theprotocol you are currently using to access the access point management interface,the current connection will end and you will not be able to access the access pointby using that protocol until it is enabled.133 Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide