MAINTENANCE MANUAL - Meritor

Special ToolsDifferential Repair Stand SpecificationsSPX Kent-Moore número de lapieza J-3409-D1 - Plates 8’ (2.44 mm) long x 3/4” (19.05 mm) thick x 1-1/4” (31.75 mm) wide with a tongue to fitslot in bar weld plates to bar2 - Handle 7” (177.8 mm) long with slot in one end to fit clamp screw3 - Bar 2” (50.8 mm) diameter x 9” (228.6 mm) long with one end slotted to fit plate4 - Weld all around after pressing plug into pipe.5 - Weld6 - Shape and size of holes to fit differential7 - 23-1/2” (596.9 mm) center to center of pipe8 - Chamfer end of pipe for welding.9 - 4” (101.6 mm) diameter pipe10 - Plug 4” (101.6 mm) diameter x 7” (177.8 mm) long with one end turned 3” (76.2 mm) long tofit pipe. Drill 2” (50.8 mm) hole and mill 3/16” (4.76 mm) wide slot 2” (50.8 mm) from top.11 - Screw 3-1/2” (88.9 mm) long x 5/8” (15.86 mm) diameter with flats onto end to fit handle and2-1/2” (63.5 mm) length of thread on other end12 - Drill 3/8” (9.5 mm) hole through handle and screw.See the Service Notes page on the front inside cover of this manual to obtain this repair stand.40 MAINTENANCE MANUAL