Roller Chain - Tsubaki

How to OrderRoller ChainDrive Chain3) When ordering an odd number of links.Specify the formation-see examples below.In case of an unspecified odd number of links, both end linkswill be treated as inner links.(1) Example of 9 links(Example of order) RS50 Roller Chain 9 linksPlease specify “with OL and Slip-fitconnecting link.”4) When ordering by the reel.There is a fixed reel length available for RS35 - RS80 singlestrand chain (table below).(Example of order) RS50 Roller Chain n reel(s)SizeRS35RS40RS50RS60RS80No. offeet/reelNo. of links100 3200100 2400100 1920100 160050 600No. of CLsincluded101010105(2) When a 2 pitch offset link is specified(Example of order) RS50 Roller Chain 9 linksPlease specify “with 2POL and Press-fitconnecting link.”This combination is possible for RSRoller Chain only.(3) Example of CLs on both ends(Example of order) RS50 Roller Chain 9 links(4) Example of inner link on both endsPlease specify “with Slip-fit connectinglinks on both ends.”RS50 Roller Chain 9 linksPlease specify “with Press-fit connectinglinks on both ends.”(Example of order) RS50 Roller Chain 9 linksPlease specify “with inner link on bothends.”(5) Example of outer link on both ends[ ]5) When ordering sprockets.(Example of order)Standard sprocket RS50 1B20T n pcsFit bore sprocket RS50 1B20TH18J n pcs(shaft hole diam.: 1”)Type 304 Stainless Steel RS50 1B20T-SS n pcsPlastic RS50 1B20T-P n pcs6) When ordering a replacement chain.1) When the roller chain size is unknown.(1) Roller chain specification. Confirm the specifications(such as Super Series type) and material (eg. stainlesssteel).(2) Identify the roller chain size/specification stamped on thelink plate.(3) Measure the roller chain pitch, roller diameter, widthbetween inner links and plate thickness.2) When the sprocket number is unknown.(1) Chain No. and number of strands.(2) Sprocket type.(3) Shaft hole diameter (Not required when shaft holeprocessing is carried out by customer).(4) Number of teeth.(5) Boss diameter and boss length (Only for special types).(6) Whether or not the teeth ends have been hardened.(7) Marking.Additionally, when the roller chain number is also unknown,please provide the following data in addition to (1) - (7)above:(8) Width of tooth (T).(9) Tooth bottom diameter (D B ) (D C for an odd number ofteeth).(Example of order) RS50 Roller Chain 9 linksPlease specify “with outer link on bothends.”[ ]When both ends are outer links, make sure to correctly carry outriveting of the pin ends using a rivet punch (refer to Chain Toolssection) after installing the chain in the machine.Note: The offset links and connecting links are supplied loosewith the chain. They are not pre-assembled on the chain.A-124