TurboCAD Pro V15 - Understanding Workplanes
TurboCAD Pro V15 - Understanding Workplanes TurboCAD Pro V15 - Understanding Workplanes
Press Space Bar to exit the tool.Select the box. Left mouse click on the reference point of the selection to pick it up. Move the cursor tothe edge of the larger box and E SEKE snap the selection in place. In progress below.Switch to Front view to confirm the smaller box is inside the original box.Switch back to Isomeric SE view.Press Esc to deselect the selection.Select the Workplane by Facet tool from the Workplane toolbar.The Workplane by Facet tool, as seen near the beginning of the tutorial, is used to select specific faces(facets) on objects with which to place the workplane.With the Workplane by Facet tool active move the cursor over some of the faces in the drawing. Do notleft mouse click at this time. Just move around.63
Here on the front face of the larger box.Here on the top face of the cylinder.Place the cursor over the "hidden" face of the smaller box as indicated in the picture below. The face onthe large box will be highlighted at this point.Press the Page Down key on the keyboard to move down to the hidden facet.64
- Page 5: Since this is a frequent need, many
- Page 9 and 10: Because the default reference point
- Page 11 and 12: Note the relationship to the world
- Page 13: Move the cursor downward and at the
Here on the front face of the larger box.Here on the top face of the cylinder.Place the cursor over the "hidden" face of the smaller box as indicated in the picture below. The face onthe large box will be highlighted at this point.Press the Page Down key on the keyboard to move down to the hidden facet.64