Proline Promass 83E/F/O Operation Manual - FMC Technologies

Commissioning Proline Promass 83!Note!6.3.5 Data backup/transmissionUsing the T-DAT SAVE/LOAD function, you can transfer data (device parameters and settings)between the T-DAT (exchangeable memory) and the EEPROM (device storage unit).This is required in the following instances:• Creating a backup: current data are transferred from an EEPROM to the T-DAT.• Replacing a transmitter: current data are copied from an EEPROM to the T-DAT and thentransferred to the EEPROM of the new transmitter.• Duplicating data: current data are copied from an EEPROM to the T-DAT and then transferred toEEPROMs of identical measuring points.For information on installing and removing the T-DAT Page 93 ff.NFig. 39:Data backup/transmission with T-DAT SAVE/LOAD functionInformation on the LOAD and SAVE options available:!Note!LOAD: Data are transferred from the T-DAT to the EEPROM.• Any settings already saved on the EEPROM are deleted.• This option is only available, if the T-DAT contains valid data.• This option can only be executed if the software version of the T-DAT is the same or newer thanthat of the EEPROM. Otherwise, the error message "TRANSM. SW-DAT" appears after restartingand the LOAD function is then no longer available.SAVE:Data are transferred from the EEPROM to the T-DATPage 66 • MN0M022Issue/Rev. 0.2 (12/12)