Proline Promass 83E/F/O Operation Manual - FMC Technologies

Commissioning Proline Promass 83"Caution!!Note!6.3.3 "Batching" Quick Setup menuThis Quick Setup menu guides you systematically through the setup procedure for all the devicefunctions that have to be parameterized and configured for batching operation. These basic settingsallow simple (one step) batching processes.Additional settings, e.g. for the calculation of after runs or for multi-stage batching procedures, mustbe made via the function matrix itself (see the "Description of Device Functions" manual).The "Batching" Quick Setup sets certain device parameters for discontinuous measurementoperation.If the measuring instrument is used for continuous flow measurement at a later time, werecommend at you rerun the "Commissioning" and/or "Pulsating Flow" Quick Setup.• Before carrying out the Quick Setup "Batching" the Quick Setup "Commissioning" has to beexecuted. ä 55• This function is only available when the additional "batching" software is installed in themeasuring device (order option). You can order this software from E+H as an accessory at a laterdate. ä 83• You can find detailed information on the batching functions in the separate "Description of DeviceFunctions" manual".• You can also directly control filling process using the local display. During Quick Setup, anappropriate dialog appears concerning the automatic display configuration. Acknowledge this byclicking "YES".This assigns special batching functions (START, PRESET, MATRIX) to the bottom line of thedisplay. These can be directly executed onsite using the three operating keys ( O / S / F ).Therefore, the measuring device can be fully deployed in the field as a "batch controller". ä 37• The Quick Setup "Batching" is not available for Promass X.Page 60 • MN0M022Issue/Rev. 0.2 (12/12)