Proline Promass 83E/F/O Operation Manual - FMC Technologies

EscECommissioning Proline Promass 83Performing the "Pulsating flow" Quick SetupThis Quick Setup menu guides you systematically through the setup procedure for all the devicefunctions that have to be parameterized and configured for measuring pulsating flows. Note that thishas no effect on values configured beforehand, such as measuring range, current range or full scalevalue!XXX.XXX.XX-+E++BQuick SetupHOME-POSITION+EQS 1003Pulsating FlowDisplay 2002dampingmSelection totalizerTotalizer 1 Totalizer 2Totalizer 3QuitTotalizer 3002 Totalizer 3002 Totalizer 3002mode (DAA)mode (DAB)mode (DAC)Yesn Configure another totalizer ?NooSelection of output typeCurrent output nFreq.-/Pulse output nQuit4200Operation mode4004Measuring mode4005Time constantFrequency4206Measuring mode4208Time constantPulse4225Measuring modeYesp Configure another output ?No8005Alarm delayAssignLF-Cut offOn-valueLF-Cut offOff-valueLF-Cut off640064026403Pressure 6404shock suppressionQuitQuick SetupFig. 36:Quick Setup for measuring severely pulsating flows. Recommended settings are found on the following page.a0002615-enmOnly the counters not yet configured in the current Setup are offered for selection in each cycle.nThe "YES" option remains visible until all the counters have been configured. "NO" is the only option displayed whenno further counters are available.oOnly the outputs not yet configured in the current Setup are offered for selection in each cycle.pThe "YES" option remains visible until all the outputs have been configured. "NO" is the only option displayed whenno further outputs are available.!Note!• The display returns to the cell QUICK SETUP PULSATING FLOW (1003) if you press the Q keycombination during parameter interrogation.• The Setups can be called up either directly after the "COMMISSIONING" Quick Setup ormanually by means of the QUICK SETUP PULSATING FLOW (1003) function.Page 58 • MN0M022Issue/Rev. 0.2 (12/12)