Proline Promass 83E/F/O Operation Manual - FMC Technologies

Operation Proline Promass 83Byte-bit Error No. Short error description Page 84 ff.16-7 65117-0 65217-1 653Simulation relay output active17-2 65417-3 66117-4 66217-5 663Simulation current input active17-6 66417-7 67118-0 67218-1 673Simulation status input active18-2 67418-3 691 Simulation of response to error (outputs) active18-4 692 Simulation of volume flow active19-0 700 The process fluid density is outside the upper or lower limit values set in the"EPD" function19-1 701 The maximum current value for the measuring tube exciter coils has beenreached,since certain process fluid characteristics are extreme.19-2 702 Frequency control is not stable, due to inhomogeneous fluid.19-3 703 NOISE LIM. CH0Overdriving of the internal analog to digital converter.A continuation of the measurement is still possible!19-4 704 NOISE LIM. CH1Overdriving of the internal analog to digital converter.A continuation of the measurement is still possible!19-5 705 The electronics' measuring range will be exceeded. The mass flow is too high.20-5 731 The zero point adjustment is not possible or has been canceled.22-4 61 F-Chip is faulty or not plugged into the I/O board.24-5 363 Current input:The actual value for the current lies outside the set limits.Page 52 • MN0M022Issue/Rev. 0.2 (12/12)