Proline Promass 83E/F/O Operation Manual - FMC Technologies

Operation Proline Promass 83!Note!5.4.5 Device status / Error messagesYou can read the extended device status, in this case, current error messages, via Command "48".The command delivers information which are partly coded in bits (see table below).Explanation of the device status and error messages and their elimination Page 84 ff.Byte-bit Error No. Short error description Page 84 ff.0-0 001 Serious device error0-1 011 Measuring amplifier has faulty EEPROM0-2 012 Error when accessing data of the measuring amplifier EEPROM1-1 031 S-DAT: Defective or missing1-2 032 S-DAT: Error accessing saved values1-3 041 T-DAT: Defective or missing1-4 042 T-DAT: Error accessing saved values1-5 051 I/O board and the amplifier board are not compatible.3-3 111 Totalizer checksum error3-4 121 I/O board and the amplifier board (software versions) are not compatible.3-6 205 T-DAT: Data download not successful3-7 206 T-DAT: Data upload not successful4-3 251 Internal communication fault on the amplifier board.4-4 261 No data reception between amplifier and I/O board5-7 3396-0 3406-1 3416-2 3426-3 3436-4 3446-5 3456-6 3466-7 3477-0 3487-1 3497-2 3507-3 3517-4 3527-5 3537-6 354Flow buffer:The temporarily buffered flow portions (measuring mode for pulsating flow) couldnot be cleared or output within 60 seconds.Frequency buffer:The temporarily buffered flow portions (measuring mode for pulsating flow) couldnot be cleared or output within 60 seconds.Pulse buffer:The temporarily buffered flow portions (measuring mode for pulsating flow) couldnot be cleared or output within 60 seconds.Current output:The actual value for the flow lies outside the set limits.7-7 3558-0 3568-1 357Frequency output:The actual value for the flow lies outside the set limits.8-2 3588-3 3598-4 3608-5 361Pulse output:Pulse output frequency is out of range.8-6 362Page 50 • MN0M022Issue/Rev. 0.2 (12/12)