Proline Promass 83E/F/O Operation Manual - FMC Technologies

Operation Proline Promass 835.1.1 Readings displayed (operation mode)The display area consists of three lines in all; this is where measured values are displayed, and/orstatus variables (direction of flow, bar graph, etc.). You can change the assignment of display linesto different variables to suit your needs and preferences ( see the "Description of DeviceFunctions" manual).Multiplex mode:A maximum of two different display variables can be assigned to each line. Variables multiplexed inthis way alternate every 10 seconds on the display.Error messages:Display and presentation of system/process errors ä 40Fig. 29: Typical display for normal operating mode (HOME position)1 Main line: shows main measured values2 Additional line: shows additional measured variables and status variables3 Information line: shows additional information on the measured variables and status variables, e.g. bargraph display4 "Info icons" field: icons representing additional information on the measured values are shown in thisfield ä 35.5 "Measured values" field: the current measured values appear in this field.6 Unit of measure" field: the units of measure and time defined for the current measured values appear in this field.5.1.2 Additional display functionsDepending on the order option, the local display has different display functions (F-CHIP ä 81).Device without batching software:From HOME position, use the P keys to open an "Info Menu" containing the following information:• Totalizer (including overflow)• Actual values or states of the configured inputs/outputs• Device TAG number (user-definable)P Scan of individual values within the Info MenuX (Esc key) Back to HOME positionDevice with batching software:On measuring instruments with installed batching software (F-Chip*) and a suitably configureddisplay line, you can carry out filling processes directly using the local display. You will find adetailed description ä 37.Page 34 • MN0M022Issue/Rev. 0.2 (12/12)