Proline Promass 83E/F/O Operation Manual - FMC Technologies

Proline Promass 83Installation3.3.3 Turning the local display1. Unscrew cover of the electronics compartment from the transmitter housing.2. Press the side latches on the display module and remove the module from the electronicscompartment cover plate.3. Rotate the display to the desired position (max. 4 × 45 ° in both directions), and reset it ontothe electronics compartment cover plate.4. Screw the cover of the electronics compartment firmly back onto the transmitter housing.Fig. 20:Turning the local display (field housing)3.4 Post-installation checkPerform the following checks after installing the measuring device in the pipe:Device condition and specificationsNotesIs the device damaged (visual inspection)? -Does the device correspond to specifications at the measuring point, includingprocess temperature and pressure, ambient temperature, measuring range, etc.?Installation instructionsDoes the arrow on the sensor nameplate match the direction of flow through thepipe?ä 5Notes-Are the measuring point number and labeling correct (visual inspection)? -Is the orientation chosen for the sensor correct, in other words suitable for sensortype, fluid properties (outgassing, with entrained solids) and fluid temperature?Process environment / process conditionsä 14NotesIs the measuring device protected against moisture and direct sunlight? -Issue/Rev. 0.2 (12/12) MN0M022 • Page 25