Proline Promass 83E/F/O Operation Manual - FMC Technologies

Proline Promass 83Technical dataRepeatabilityDesign fundamentals ä 121.• Mass flow and volume flow (liquids):±0.025% o.r. (PremiumCal, for mass flow)±0.05% o.r.• Mass flow (gases): ±0.25% o.r.• Density (liquids): ±0.00025 g/cm 3• Temperature: ±0.25 °C ± 0.0025 · T °C; ±0.5 °F ± 0.0015 · (T - 32) °FInfluence of medium temperatureWhen there is a difference between the temperature for zero point adjustment and the processtemperature, the typical measured error of the sensor is ±0.0002% of the full scale value / °C(±0.0001% of the full scale value/°F).Influence of medium pressureThe table below shows the effect on accuracy of mass flow due to a difference between calibrationpressure and process pressure.DNPromass F (standard)[mm] [inch] [% o.r./bar]80 3 –0.0055100 4 –0.0035150 6 –0.002Design fundamentalsDependent on the flow:•Flow Zero point stability ÷ (Base accuracy ÷ 100)– Max. measured error: ±Base accuracy in % o.r.– Repeatability: ± ½ · Base accuracy in % o.r.• Flow < Zero point stability ÷ (Base accuracy ÷ 100)– Max. measured error: ± (Zero point stability ÷ measured value) · 100% o.r.– Repeatability: ± ½ · (Zero point stability ÷ measured value) · 100% o.r.Base accuracy forMass flow liquids, PremiumCal 0.05Mass flow liquids 0.10Volume flow liquids 0.10Mass flow gases 0.35Issue/Rev. 0.2 (12/12) MN0M022 • Page 121