Proline Promass 83E/F/O Operation Manual - FMC Technologies

Proline Promass 83Identification2.2 Certificates and approvalsThe devices are designed in accordance with good engineering practice to meet state-of-the-artsafety requirements, have been tested, and left the factory in a condition in which they are safe tooperate. See also "Certificates and approvals" ä 147.The devices comply with the applicable standards and regulations in accordance with EN 61010-1"Protection Measures for Electrical Equipment for Measurement, Control, Regulation andLaboratory Procedures" and with the EMC requirements of IEC/EN 61326.The measuring system described in these Operating Instructions thus complies with the statutoryrequirements of the EC Directives. confirms successful testing of the device byaffixing to it the CE mark.The measuring system meets the EMC requirements of the "Australian Communications and MediaAuthority (ACMA)".2.3 Registered trademarksKALREZ ® and VITON ®Registered trademarks of E.I. Du Pont de Nemours & Co., Wilmington, USATRI-CLAMP ®Registered trademark of Ladish & Co., Inc., Kenosha, USASWAGELOK ®Registered trademark of Swagelok & Co., Solon, USAHART ®Registered trademark of HART Communication Foundation, Austin, USAHistoROM, S-DAT ® , T-DAT, F-CHIP ® , FieldCare ® , Fieldcheck ® , Field Xpert, Applicator ®Registered or registration-pending trademarks of Endress+Hauser Flowtec AG, Reinach, CHIssue/Rev. 0.2 (12/12) MN0M022 • Page 11