12.07.2015 Views

Proline Promass 83E/F/O Operation Manual - FMC Technologies

Proline Promass 83E/F/O Operation Manual - FMC Technologies

Proline Promass 83E/F/O Operation Manual - FMC Technologies

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Technical data <strong>Proline</strong> <strong>Promass</strong> 83Input signalStatus input (auxiliary input):U = 3 to 30 V DC, R i = 5 k, galvanically isolated.Configurable for: totalizer reset, positive zero return, error message reset, start zero pointadjustment, batching start/stop (optional)Current input:Active/passive selectable, galvanically isolated, resolution: 2 A• Active: 4 to 20 mA, R L < 700 , U out = 24 V DC, short-circuit proof• Passive: 0/4 to 20 mA, R i = 150 , U max = 30 V DC10.1.4 OutputOutput signalCurrent output:Active/passive selectable, galvanically isolated, time constant selectable (0.05 to 100 s), full scalevalue selectable, temperature coefficient: typically 0.005% of full scale value/°C, resolution: 0.5 A• Active: 0/4 to 20 mA, R L < 700 (for HART: R L 250 )• Passive: 4 to 20 mA; supply voltage U S 18 to 30 V DC; R i 150 Pulse/frequency output:Active/passive selectable, galvanically isolated• Active: 24 V DC, 25 mA (max. 250 mA during 20 ms), R L > 100 • passive: open collector, 30 V DC, 250 mA• Frequency output: full scale frequency 2 to 10000 Hz (f max = 12500 Hz), on/off ratio 1:1, pulsewidth max. 2 s• Pulse output: pulse value and pulse polarity selectable, pulse width configurable (0.05 to2000 ms)Signal on alarmLoadCurrent output:Failsafe mode selectable (for example, according to NAMUR Recommendation NE 43)Pulse/frequency output:Failsafe mode selectableRelay output:De-energized in the event of fault or power supply failureSee "Output signal"Switching outputRelay output:Normally closed (NC or break) or normally open (NO or make) contacts available (default: relay 1 = NO, relay 2 = NC), max. 30V / 0.5 A AC; 60 V / 0.1 A DC, galvanically isolated.Configurable for: error messages, Empty Pipe Detection (EPD), flow direction, limit values, batchingvalve 1 and 2 (optional).Low flow cut offSwitch points for low flow cut off are selectable.Galvanic isolationAll circuits for inputs, outputs, and power supply are galvanically isolated from each other.Page 106 • MN0M022Issue/Rev. 0.2 (12/12)

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!