Download - Xerox Support and Drivers

NOTE: If your printer is not already connected to thecomputer, the following window will appear.Installing Software for Network PrintingWhen you connect your printer to a network, you must firstconfigure the TCP/IP settings for the printer. After you haveassigned and verified the TCP/IP settings, you are ready toinstall the software on each computer on the network.You can install the printer software using the typical or custommethod.Typical InstallationThis is recommended for most users. All components necessaryfor printer operations will be installed.• After connecting the printer, click Next.• If you don’t want to connect the printer at this time, clickNext, and No on the following screen. Then the installationwill start and a test page will not be printed at the end of theinstallation.• The installation window that appears in this User’sGuide may differ depending on the printer andinterface in use.1 Make sure that the printer is connected to your networkand powered on. For details about connecting to thenetwork, see the supplied printer’s User’s Guide.2 Insert the supplied CD-ROM into your CD-ROM drive.The CD-ROM should automatically run, and an installationwindow appears.If the installation window does not appear, click Start andthen Run. Type X:\Setup.exe, replacing “X” with theletter which represents your drive and click OK.6 Select the components to be installed and click Next.3 Click Install Software.NOTE: You can change the desired installation folder byclicking [Browse].4 Select Typical installation for a network printer. ClickNext.7 After the installation is finished, a window asking you toprint a test page appears. If you choose to print a testpage, select the checkbox and click Next.Otherwise, just click Next and skip to step 9.8 If the test page prints out correctly, click Yes.If not, click No to reprint it.9 Click Finish.6Installing Printer Software in Windows