Download - Xerox Support and Drivers

10 Installing accessoriesYour printer is a full-featured laser printer that has been optimized tomeet most of your printing needs. Recognizing that each user may havedifferent requirements, however, Xerox makes several accessoriesavailable to enhance the printer’s capabilities.This chapter includes:• Precautions when installing accessories• Installing a memory DIMMPrecautions when installing accessoriesDisconnect the power cord:Never remove the control board cover while the power is being supplied.To avoid the possibility of an electrical shock, always disconnect thepower cord when installing or removing ANY internal or externalaccessories.2 Grasp the control board cover and slide toward you to open it.3 Take out a new memory DIMM from the plastic bag.4 Holding the memory DIMM by the edges, align the notches on thememory DIMM with the grooves on the memory DIMM slot.11 control board coverDischarge static electricity:The control board and internal accessories (network interface card andmemory DIMM) are sensitive to static electricity. Before installing orremoving an internal accessories, discharge static electricity from yourbody by touching something metal, such as the metal back plate on anydevice plugged into a grounded power source. If you walk round beforefinishing installation, discharge any static electricity once again.Installing a memory DIMMYour printer has a dual in-line memory module (DIMM) slot. Use thisDIMM slot to install additional memory.The Phaser 3428/D has 32 MB of memory which can be expanded to288 MB. The Phaser 3428/DN have 64 MB of memory which can beexpanded to 320 MB.For order information for optional memory DIMMs, see page 7.1.1 Turn the printer power off and unplug all cables from the printer.5 Push the DIMM straight into the DIMM slot until it snaps into place.Make sure the latches fit over the notches located on either side ofthe DIMM.6 Replace the control board cover.7 Reconnect the power cord and printer cable, and turn the printer on.10.1