Download - Xerox Support and Drivers

For information about setting the paper source and type on thecontrol panel, see page 2.3.6 After printing, fold the multi-purpose tray extension and close themulti-purpose tray.Tips on using the multi-purpose tray• Load only one size of print media at a time in the multi-purpose tray.• To prevent paper jams, do not add paper when there is still paper inthe multi-purpose tray. This also applies to other types of print media.• Print media should be loaded face up with the top edge going into themulti-purpose tray first and be placed in the center of the tray.• Always load only the print media specified in page 5.1 to avoid paperjams and print quality problems.• Flatten any curl on postcards, envelopes, and labels before loadingthem into the multi-purpose tray.• When you print on 76 mm x 127 mm (3 x 5 inches) sized media onthe multi-purpose tray, open the rear cover for straight paper path toavoid paper jams.• Make sure to open the rear cover when you print on transparencies. Ifnot, they may tear while exiting the printer.Using manual feed modeYou can manually load a sheet of print material in the multi-purpose trayif you select Manual Feeder in the Source option from the Paper tabwhen you change print settings to print a document. See the SoftwareSection. Manually loading paper can be helpful when you want to checkthe print quality after each page is printed.This loading procedure is almost the same as the procedure for loadingin the multi-purpose tray, except you load paper sheet-by-sheet in thetray, send print data to print the first page, and press Stop on the controlpanel to print each following page.1 Load the paper with the side to be printed on facing up.2 Squeeze the multi-purpose tray paper width guides and adjustthem to the width of the paper. Do not force too much, or the paperwill be bent, which will result in a paper jam or skew.3 When you print a document, set the paper source to ManualFeeder and select the appropriate paper size and type in thesoftware application. See the Software Section.4 Print a document.The display shows a message prompting you to load paper andpress Stop .5 Press Stop.The printer picks up the print material and prints. After one page isprinted, the message appears again.NoteIf you do not press the button, after a pause the printer willautomatically pick the print material.6 Insert the next sheet into the multi-purpose tray and press Stop.Repeat this step for every page to be printed.5.7