Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications9.11.5 CR_P-TIMER CommandCommandDetailsResponse“CR_P-TIMER” [CR]Get Presentation Timer operating statusAcceptable%1Unacceptable“000_%1” [CR]“ON” ---------------------------- Presentation Timer is ongoing.”STOP” ------------------------ Presentation Timer is paused.“OFF” -------------------------- Presentation Timer is not active.“?” [CR]9.11.6 CR_TEMPWARN CommandCommandDetailsResponse“CR_TEMPWARN” [CR]Get the information about the temperature inside the projector (close to theabnormal or in the abnormal status/in the safe temperature level/abnormal statusis not detected).It is possible to get the information about more than one sensor all at once if it isapplicable.Acceptable%1“000_%1” [CR]“*_*”Sensor 1 data comes first, and then one space, after that sensor2 data is followed.Each data is as below:“W”--- in or close to the abnormal temp. (Warning Temp.)“S”--- in the safe level of temperature (Safe Temp.).“N”--- the given sensor does not detect abnormal temp.Unacceptablee.g. “S_W” [CR] indicates that the temperature detected atSensor 1 is in the safe level while Sensor 2 in the abnormaltemperature.“?” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)96/101