Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications9.11 Other Status Read Commands9.11.1 CR_STATUS CommandCommandDetailsResponse“CR_STATUS” [CR]Get operating status of ProjectorSame as “CR0” in basic command except error code follows it.Acceptable%1Unacceptable“000_%1” [CR]“00” = Power ON“80” = Standby“40” = Countdown in process“20” = Cooling Down in process“10” = Power Failure“28” = Cooling Down in process due to abnormal temperature“88” =Standby after Cooling Down due to abnormal temperature“02” = Invalid RS-232C Command“24” = Power Save/Cooling Down in process“04” = Power Save“21” = Cooling Down in process after turned off due to lamp failure“81”= Standby after Cooling Down due to lamp failure“2C” = Cooling Down in process after Power Off due toShutter management“8C” = Standby after Cooling Down due to Shutter management“Error Code” [CR]9.11.2 CR_SIGNAL CommandCommandDetailsResponse“CR_SIGNAL” [CR]Get status if there is any signal or notAcceptable%1Unacceptable“000_%1” [CR]“ON” -------------------------- There is signal“OFF” ------------------------ There is no signal“?” [CR]9.11.3 CR_VMUTE CommandCommandDetailsResponse“CR_VMUTE” [CR]Get Video mute setting statusAcceptable%1Unacceptable“000_%1” [CR]“ON” ------------------------ Video mute is set to ON (Shutter Close).“OFF” ---------------------- Video mute is set to OFF (Shutter Open).“?” [CR]9.11.4 CR_FREEZE CommandCommandDetailsResponse“CR_FREEZE” [CR]Get Freeze setting statusAcceptable%1Unacceptable“000_%1” [CR]“ON” ---------------------------- Freeze is set to ON.“OFF” -------------------------- Freeze is set to OFF.“?” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)95/101