Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications9.9 Lamp Status Read Commands9.9.1 CR_LAMPREPL CommandCommandDetailsResponse“CR_LAMPREPL” [CR]Get the information of Lamp Replacement timeAcceptable%1Unacceptable“000_%1” [CR]“2**”2 ---------------- indicates 2 lamps are used in this model.* ---------------- indicates the status of each lamp in lamp numberorder.“Y” means the lamp operating time is over thethreshold for lamp replacement, and “N” meansit has not reached to.e.g.“2YN” ------------ This indicates it is 2-lamp system, and Lamp #2has not been reached to the replacement timewhile #1 should be replaced.“?” [CR]9.9.2 CR_LAMPMODE CommandCommandDetailsResponse“CR_LAMPMODE” [CR]Get Lamp mode setting statusAcceptable%1Unacceptable“000_%1” [CR]“FULL” ---------------- Lamp mode is set to 2-lamp (FULL)“LAMP1”-------------- Lamp mode is set to Lamp1“LAMP2” ------------- Lamp mode is set to Lamp2“?” [CR]9.9.3 CR_AUTOLAMPCONTRL CommandCommandDetailsResponse“CR_AUTOLAMPCONTRL” [CR]Get selected Lamp control modeAcceptable%1Unacceptable“000_%1” [CR]“NORMAL” ---------- NORMAL is selected.“ECO1” --------------- ECO1 is selected.“ECO2” --------------- ECO2 is selected.“Error Code” [CR]9.9.4 CR_LAMPSTS CommandCommandDetailsResponse“CR_LAMPSTS” [CR]Get the information of Lamp lighting statusAcceptable%1Unacceptable“000_%1” [CR]“2**”The first character indicates 2 lamps are used in this model.The following characters indicate each lamp status in lampnumber order as showed below.“I” ------------------------ Lamp is ON“O” ---------------------- Lamp is OFF“X” ----------------------- Lamp Failuree.g.“2IO” ------------------- This indicates it is 2-lamps system, Lamp#1 is ON, and #2 is OFF.“?” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)78/101