Christie DHD800 Serial Communications Protocol-Extended

More documents

Recommendations

Info

PDG-DHT8000L Expand Serial Command Functional Specifications9.7.18 CR_IDSLOT4 CommandCommandDetailsResponse“CR_IDSLOT4” [CR]Get ID information on Slot 4.This command is to recognize the inserted slot board and specify the valid Inputsource.Acceptable“000_%1” [CR]%1 The same as CR_IDSLOT1Unacceptable“?” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)75/101
PDG-DHT8000L Expand Serial Command Functional Specifications9.8 Screen Status Read Commands9.8.1 CR_SCREEN CommandCommandDetailsResponse“CR_SCREEN” [CR]Get currently selected screen image sizeAcceptable%1Unacceptable“000_%1” [CR]“NORMAL” ---------------------- Normal mode“ZOOM” -------------------------- Zoom mode“NATURAL” -------------------- Natural wide mode“FULL” --------------------------- Full mode“TRUE” --------------------------- True mode“CUSTOM” ----------------------- Custom mode“Error Code” [CR] -------------- When command is invalid in thegiven condition (such as being selected input)“?” [CR] ----------------------- When unknown command is received9.8.2 CR_KYSTNMODE CommandCommandDetailsResponse“CR_KYSTNMODE” [CR]Get setting status of Keystone Store ModeAcceptable%1Unacceptable“000_%1” [CR]“STR” ---------------------- Store mode is “Store”“RST” ---------------------- Store mode is “Reset”“?” [CR] -------------------- When unknown command is received9.8.3 CR_CEIL CommandCommandDetailsResponse“CR_CEIL” [CR]Get setting status of CeilingAcceptable%1Unacceptable“000_%1” [CR]“ON” --------------------------- Ceiling projection is enabled“OFF” ------------------------- Ceiling projection is disabled“Error Code” [CR]9.8.4 CR_REAR CommandCommandDetailsResponse“CR_REAR” [CR]Get setting status of Rear functionAcceptable%1Unacceptable“000_%1” [CR]“ON” --------------------------- Rear projection is enabled“OFF” ------------------------- Rear projection is disabled“Error Code” [CR]9.8.5 CR_VSCALE CommandCommand “CR_VSCALE” [CR]Details Get setting status of V scaleAcceptable “000_%1” [CR]Response %1 “-32”-”035”Unacceptable “Error Code” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)76/101
Page 1 and 2:
DHD800 RS232 Codes-ExpandTechnical
Page 4 and 5:
PDG-DHT8000L Expand Serial Command
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27: PDG-DHT8000L Expand Serial Command
Page 102: PDG-DHT8000L Expand Serial Command
show all

Christie DHD800 Serial Communications Protocol-Extended

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?