Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications9.7.14 CR_NMSLOT4 CommandCommand “CR_NMSLOT4” [CR]Details Get the board name inserted to Slot 4Acceptable “000_%1” [CR]Response %1 The same data as CR_NMSLOT1Unacceptable “?” [CR]9.7.15 CR_IDSLOT1 CommandCommandDetailsResponse“CR_IDSLOT1” [CR]Get ID information on Slot 1.This command is used to recognize the insertedboard and specify the valid Input source.Acceptable%1Unacceptable“000_%1” [CR]“08” --------------- DUAL-SDI boardValid Input Source: SDI1, SDI2“18” --------------- New HDCP-DVI boardValid Input Source: DIGITAL, ANALOG, HDCP, SCART“19” --------------- New Component & Video boardValid Input Source: ANALOG, YPBPR, VIDEO, S-VIDEO“32” --------------- On-board(DVI-D+D-Sub+HDMI)Valid Input Source: DIGITAL, ANALOG, HDCP, SCART,HDMI“42” --------------- On-board(5BNC+S-video)Valid Input Source: ANALOG, YPBPR, VIDEO, S-VIDEO“99” --------------- No board inserted“?” [CR]9.7.16 CR_IDSLOT2 CommandCommandDetailsResponse“CR_IDSLOT2” [CR]Get ID information on Slot 2.This command is to recognize the inserted slot board and specify the valid Inputsource.Acceptable“000_%1” [CR]%1 The same as CR_IDSLOT1Unacceptable“?” [CR]9.7.17 CR_IDSLOT3 CommandCommandDetailsResponse“CR_IDSLOT3” [CR]Get ID information on Slot 3.This command is to recognize the inserted slot board and specify the valid Inputsource.Acceptable“000_%1” [CR]%1 The same as CR_IDSLOT1Unacceptable“?” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)74/101