Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications9.5.9 CR_ORGMODE CommandCommandDetailsResponse“CR_ORGMODE” [CR]Get the original signal of current selected Mode that is set in PC Adj.When MODE1- 10 or EXT11-60 is not selected, get the current signal.Acceptable%1“000_%1” [CR]When input signal is PC Analog;“VGA1” ------------------------ Indicates signal Is VGA1“VGA2” ------------------------ Indicates signal is VGA2::“XGA1” ------------------------ Indicates signal is XGA1::“WXGA3” --------------------- Indicates signal is WXGA3“1080i60” --------------------- Indicates signal is 1080i60“1080i50” --------------------- Indicates signal is 1080i50“1035i” ------------------------ Indicates signal is 10350i“720p60” --------------------- Indicates signal is 720p60“720p50” --------------------- Indicates signal is 720p50“575p” ------------------------- Indicates signal is 575p“480p” ------------------------- Indicates signal is 480p“575i” -------------------------- Indicates signal is 575i“480i” -------------------------- Indicates signal is 480i“1080psf/24” ----------------- Indicates signal is 1080psf/24“1080psf/25” ----------------- Indicates signal is 1080psf/25“1080psf/30” ----------------- Indicates signal is 1080psf/30“1080p24” -------------------- Indicates signal is 1080p24“1080p25” -------------------- Indicates signal is 1080p25“1080p30” -------------------- Indicates signal is 1080p30“1080p50” -------------------- Indicates signal is 1080p50“1080p60” -------------------- Indicates signal is 1080p60UnacceptableNote; To differentiate between 60Hz and 50Hz in 1080i and 720p,“60” or “50” is necessary to add to the parameter in this command* When input signal is not PC Analog, error code “101” isreturned.“?” [CR]9.5.10 CR_PCSTORE CommandCommandDetailsResponse“CR_PCSTORE” [CR]Get Free or Stored status of MODE1 - 5 in PC Adjust.Data consists of 10 bytes and each byte represents MODE1-10.(F:Free, S:Stored)Acceptable%1“000_%1” [CR]“FFFFFFFFFF” ---------------- ALL Free“SFFFFFFFFF” --------------- Mode1 is Stored, others are Free:“FFFFFFFFFS” --------------- Mode10 is Stored, others are Free“SSSSSSSSSS” ------------- ALL StoredUnacceptable“Error Code” [CR] -------------- When command is invalid in thegiven condition (such as being selected input)“?” [CR] --------- When unknown command is receivedDHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)67/101