Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications8.9.59 CF_SHUTRELEASE CommandCommand%1DetailsResponse“CF_SHUTRELEASE_%1” [CR]“ANY”----------Enable to release Shutter with any key“SHUTTER” ------------------ Enable to release Shutter with only “SHUTTER” keySet Release key of Shutter.(Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.60 CF_DELAYCTRL CommandCommand%1DetailsResponse“CF_DELAYCTRL_%1” [CR]“OFF”---------- Set Video delay control to OFF“LOW”---------- Set Video delay control to LOW“MID”----------- Set Video delay control to MID“HIGH”---------- Set Video delay control to HIGHSelect the mode of Video delay control(Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.61 CF_CCAPTIONDISP CommandCommand%1DetailsResponse“CF_CCAPTIONDISP_%1” [CR]“OFF” ------------- Select Off“CC1” ------------- Select CC1“CC2” ------------- Select CC2“CC3” ------------- Select CC3“CC4” ------------- Select CC4Select channel of Closed caption.The status set with this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF. This command is available in normal Power ON status.Note)Closed caption is available under conditions below;Entered signal is appropriate (Video, NTSC signal of S-video) and System is fixedto NTSC.AcceptableUnacceptable“000” [CR]“Error Code” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)55/101