Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications8.9.41 CF_FANSPEED CommandCommand%1DetailsResponse“CF_FANSPEED_%1” [CR]“MAX” ---------------------------- Select Maximum speed of Fan Control“NOR” ---------------------------- Select Normal speed of Fan ControlSwitch Fan Control Speed. (Valid only when in the normal Power ON status.)The status set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.42 CF_RCODE CommandCommand%1DetailsResponse“CF_RCODE_%1” [CR]“001” ------------------------------------ Select Code 1“002” ------------------------------------ Select Code 2“003” ------------------------------------ Select Code 3“004” ------------------------------------ Select Code 4“005” ------------------------------------ Select Code 5“006” ------------------------------------ Select Code 6“007” ------------------------------------ Select Code 7“008” ------------------------------------ Select Code 8“UP” ---------- Switch forward (Code1→Code2→Code3 - - - →Code8→Code1)“DN” --------- Switch backward (Code8→Code7→Code6 - - -→Code1→Code8)Select Remote Control Code (Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.43 CF_RSENS CommandCommand%1DetailsResponse“CF_RSENS_%1” [CR]“ALL” -------------------------- Select all receiver of projector“FRONTTOP” ---------------- Select both front and top receiver of projector“BACKTOP” ------------------ Select both back and top receiver of projector“FRONTBACK” -------------- Select both front and back receiver of projector“FRONT” ---------------------- Select only front receiver of projector“TOP” -------------------------- Select only top receiver of projector“BACK” ------------------------ Select only back receiver of projector“UP” ---------------- Switch forward (ALL → FRONTTOP→BACKTOP→FRONTBACK→ FRONT →TOP → BACK→ALL)“DN” ---------------- Switch backward (BACK →TOP→FRONT→FRONTBACK→BACKTOP →FRONTTOP→ ALL→BACK)Select location of infrared remote receiver of remote control (Available only in thenormal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.AcceptableUnacceptable“000” [CR]“Error Code” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)50/101