Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications8.9.10 CF_PIPSUBINPU CommandCommand%1%2DetailsResponse“CF_PIPSUBINP_%1_%2” [CR]“1” -------------------- Select Input 1“2” -------------------- Select Input 2“3” -------------------- Select Input 3“4” -------------------- Select Input 4“DIGITAL” ---------------- Select DVI Input“ANALOG” --------------- Select Analog Input“VIDEO” ------------------- Select Composite Video Input“S-VIDEO” ---------------- Select S-Video input“YPBPR” ------------------ Select Y/Pb/Pr Input“YCBCR” ------------------ Select Y/Cb/Cr Input“SDI1” --------------------- Select SDI 1 Input“SDI2” --------------------- Select SDI 2 Input“SCART” ------------------ Select SCART Input“HDCP” -------------------- Select HDCP Input“HDMI” -------------------- Select HDMI InputSelect input and source of Sub picture of “Picture in Picture”. (Valid only when inthe normal Power ON status.)* In the case of a specific status, return “101” [CR] and the command is notexecuted.- When selected Source does not meet the requirement for Input- When transmitted command of the input without inserting Board in Input3or Input4- When selected Input / Source which was impossible of choice by limit of“Picture in Picture”AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.11 CF_PIPSIZE CommandCommand%1%2DetailsResponse“CF_PIPSIZE_%1_%2” [CR]“1” -------------------- Set main picture size to 10%“2” -------------------- Set main picture size to 20%“3” -------------------- Set main picture size to 30%“4” -------------------- Set main picture size to 40%“5” -------------------- Set main picture size to 50%“6” -------------------- Set main picture size to 60%“7” -------------------- Set main picture size to 70%“8” -------------------- Set main picture size to 80%“9” -------------------- Set main picture size to 90%“10” ------------------ Set main picture size to 100%“1” -------------------- Set sub picture size to 10%“2” -------------------- Set sub picture size to 20%“3” -------------------- Set sub picture size to 30%“4” -------------------- Set sub picture size to 40%“5” -------------------- Set sub picture size to 50%Set display size of “Picture in Picture”. (Valid only when in the normal Power ONstatus.)*When “Picture in Picture” is set to Off, return “101” [CR]AcceptableUnacceptable“000” [CR]“Error Code” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)41/101