Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications8.9.8 CF_PIPMODE CommandCommand%1DetailsResponse“CF_PIPMODE_%1” [CR]“PINP” -------------------- Select P in P mode“PBYP” ------------------- Select P by P modeSet mode of ”Picture in Picture”. (Available only in the normal Power ON status)AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.9 CF_PIPMAININP CommandCommand%1%2DetailsResponse“CF_PIPMAININP_%1_%2” [CR]“1” -------------------- Select Input 1“2” -------------------- Select Input 2“3” -------------------- Select Input 3“4” -------------------- Select Input 4“DIGITAL” ---------------- Select DVI Input“ANALOG” --------------- Select Analog Input“VIDEO” ------------------- Select Composite Video Input“S-VIDEO” ---------------- Select S-Video input“YPBPR” ------------------ Select Y/Pb/Pr Input“YCBCR” ------------------ Select Y/Cb/Cr Input“SDI1” --------------------- Select SDI 1 Input“SDI2” --------------------- Select SDI 2 Input“SCART” ------------------ Select SCART Input“HDCP” -------------------- Select HDCP Input“HDMI” -------------------- Select HDMI InputSelect input and source of Main picture of “Picture in Picture”. (Valid only when inthe normal Power ON status.)* In the case of a specific status, return Error Code “101” [CR] and thecommand is not executed.- When selected Source does not meet the requirement for Input- When transmitted command of the input without inserting Board in Input3or Input4- When selected Input / Source which was impossible of choice by limit ofPicture in PictureAcceptableUnacceptable“000” [CR]“Error Code” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)40/101