Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications8.9.4 CF_MENUSIZE CommandCommand%1DetailsResponse“CF_MENUSIZE_%1” [CR]“NORMAL” -------------------- Select Menu size to Normal.“DOUBLE” --------------------- Select Menu size to Double.Select Menu size. (Valid only when in the normal Power ON status.)The status set by this command is stored in EEPROM and the setting remainseven after the power is turned to ALL OFF status.AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.5 CF_DISP CommandCommand%1DetailsResponse“CF_DISP_%1” [CR]“ON” ----------------------------- Set Display to ON“CNTDWNOFF” -------------- Set Display to Count down Off“OFF” --------------------------- Set Display to OFF“UP” --------------- Switch forward (On → Count down Off → Off → On → ---)“DN” --------------- Switch backward (On → Off → Count down Off → On → ---)Set/Cancel Display. (Valid only when in the normal Power ON status.)The value set by this command is stored in EEPROM and the setting remainseffective after the power is turned to ALL OFF status.AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.6 CF_BACKGND CommandCommand%1DetailsResponse“CF_BACKGND_%1” [CR]“BLUE” -------------------- Select Blue Back“USER” ------------------- Select User“BLACK” ------------------ Select Black Back“UP” ---------- Switch forward (Blue Back→User→Black Back→Blue Back)“DN” --------- Switch backward (Blue Back→Black Back→User→Blue Back)Set Screen status for no signal.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and the setting remainseven after the power is turned to ALL OFF status.*When %1=”USER” is received, error code “101” is returned, in the case ofCapture non-practice.AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.9.7 CF_PIP CommandCommand%1DetailsResponse“CF_PIP_%1” [CR]“OFF” -------------------- Select Off“USER1” ---------------- Select User1“USER2” ---------------- Select User2“USER3” ---------------- Select User3“USER4” ---------------- Select User4“USER5” ---------------- Select User5Set ”Picture in Picture” status.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and the setting remainseven after the power is turned to ALL OFF status.AcceptableUnacceptable“000” [CR]“Error Code” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)39/101