Christie DHD800 Serial Communications Protocol-Extended

PDG-DHT8000L Expand Serial Command Functional Specifications8.4.5 CF_COLMNSAV CommandCommand“CF_COLMNSAV_%1” [CR]%1 “000 – 009” ---------------- Specify the area to storeDetailsResponseStore current setting status of Color Management to the area specified in %1.(Available only in the normal Power ON status)AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.4.6 CF_COLMNLD CommandCommand“CF_COLMNLD_%1” [CR]%1 “000 – 009” ---------------- Specify the area to storeDetailsResponseRetrieve Color Management setting status from the area specified in %1.(Available only in the normal Power ON status)AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.4.7 CF_APCTRL CommandCommand%1DetailsResponse“CF_APCTRL_%1” [CR]“L1” ------------------- Set Auto Picture Control to Level 1.“L2” ------------------- Set Auto Picture Control to Level 2.“OFF” ---------------- Set Auto Picture Control OFF.“ UP” ------------------ Switch setting forward direction (OFF→L1→L2→OFF)“ DN” ------------------ Switch setting backward direction (OFF→L2→L1→OFF)Set Auto Picture Control (Available only in the normal Power ON status)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)AcceptableUnacceptable“000” [CR]“Error Code” [CR]8.4.8 CF_COLTEMP CommandCommand “CF_COLTEMP_%1” [CR]%1 “000” – “003”DetailsResponseSet Color Temperature (Available only in the normal Power ON status)The value set by this command is not stored in the projector’s memory. Therefore,when the power is turned to ALL OFF status, the value returns to the originalsetting. (It is stored in Suspend mode.)AcceptableUnacceptable“000” [CR]“Error Code” [CR]DHD800 RS232 Codes-Expand Technical Ref.020-000582-01 Rev. 1 (11-2012)23/101