Owner's Manual 2011 CR/WR/XC 125/150 - Husqvarna

REPLACING THE NUMBER PLATE LAMP (WR)Pull out the number plate lampholder (4) from the back of thevehicle. Pull out the lampholder and the bulb. Rotate the bulb(5) to remove from the lampholder.Once the bulb has been replaced, reverse the above procedure.ADJUSTMENT OF HEADLIGHT (WR)When checking the proper orienting of headlight, inflate tiresat right pressure, sat a person on the saddle and place the motorcycleperpendicular with its longitudinal axis 10 meter (33ft) from a wall or screen. Then trace an horizontal line equal tothe height of headlight center and a vertical one in line with itslongitudinal axis.If possibile, execute this operation in a shadowy place.When the low beam is on, the upper boundary limit betweendark and lit zone should be 9/10 th of headlight center fromgroud.Adjust the preadlamp aiming by turning screw (1) to lower orlift the high beam.41546