Owner's Manual 2011 CR/WR/XC 125/150 - Husqvarna

2. Clean ringnut (1) and adjusting nut (2) of the spring (3).3. Either with a hook wrench or an aluminium punch, loosenthe ringnut .4. Turn the adjusting nut as required.5. When the adjusting operation is over (according to yourweight and riding style), tighten the ringnut. (Torque forboth ringnuts: 5 Kgm; 49 Nm; 36.2 ft/lb).6. Reassemble R.H. side panel and saddle.WARNING*:Be careful not to touch hot exhaustpipe while adjusting the shock abosrber.SHOCK ABSORBER DAMPING ADJUSTMENTAdjustment of the compression stroke is independent from therebound stroke.A) COMPRESSION - Standard calibration:1) Low damping speed:- 15 clicks (± 2 clicks)(register 4)2) High damping speed:- 15 clicks (± 2 clicks)(register 6)To reset the standard calibration, turn upper registers (4) and(6) clockwise until reaching fully closed position.Return then back for the mentioned clicks. In order to obtain asmooth braking action, turn the registers anticlockwise. Reversethe operation in order to obtain a harder braking action.B) EXTENSION - Standard calibration:- 18 clicks (± 2 clicks)To reset the standard calibration, turn lower register (5) clockwiseuntil reaching fully closed position. Return then back forthe mentioned clicks. In order to obtain a smooth brakingaction, turn the register anticlockwise. Reverse the operationin order to obtain a harder braking action132532