Owner's Manual 2011 CR/WR/XC 125/150 - Husqvarna

The standard calibrations and the adjustment procedures areshown below.ADJUSTING THE COMPRESSION FORKa) COMPRESSION (CR: UPPER REGISTER; WR: LOWER REGISTER)Standard calibration: -9 clicks (CR)Standard calibration: -10 clicks (WR)Remove plug (B) and turn register (A) clockwise until the positionof fully closed is reached then, turn back by the mentionedclicks.To obtain a smoother braking action, turn the registeranticlockwise. Reverse the operation in order to obtain a harderaction.b) EXTENSION (CR: LOWER REGISTER; WR: UPPER REGISTER)Standard calibration: -13 clicks (CR)Standard calibration: -10 clicks (WR)To reset standard calibration turn register (C) clockwise to reachthe position of fully closed; then, turn back by the mentionedclicks. To obtain a smoother braking action, turn the registeranticlockwise. Reverse the operation in order to obtain a harderaction.c) AIR VENT (to carry out after each competition, or monthly).Set the motorcycle on a central stand and release the fork fullyand loosen the air vent valve (D). Once this operation is over,tighten the valve.- WR:WARNING: Never force the adjusting screwsbeyond the maximum opening and closurepositions.OIL FORK LEVELFor the regular fork operation, both legs must be provided withthe necessary oil quantity.OIL QUANTITY IN EACH FORK LEG- CR: 352 cm 3b)CRemove the fork legs from the fork to check the oil level. Workas follows:- remove the damper rod caps;- remove springs from the legs letting the oil drain into thelegs;- bring fork to stroke end;- check that level is at the distance (A) of 140 mm (5,51 in.)from rod upper limit.NOTEAlways replace both the spring and the spacers to keep thepreload value unchanged.a) A a)b) C CRDADWRWRAENWRCR29