Owner's Manual 2011 CR/WR/XC 125/150 - Husqvarna

More documents

Recommendations

Info

ENGINE STARTFor the correct start of a cold engine proceed as follows:- shift the transmission into neutral;- set fuel valve (1) in ON position;- lift the knob lever (3) on the carburetor.Leaving the throttle in closed position operate kick-start (4).Take the knob lever in its initial position as soon as the engineis idling.When starting with an already warmed up engine DO NOT USEthe starter. You can start the engine with the gear inserted, afterdisconnecting of the clutch.If the carburetor is flooded, shut off the fuel supply and thestarter and operate the crank lever or the kick-start until theengine starts. If necessary, remove the spark plug and dry it.IMPORTANT NOTE IN CASE OF COLD STARTSAT LOW TEMPERATURESIt is recommended to briefly warm-upthe engine at idle until, after havingdisengaged the starter, there is a normalresponse from the engine whenopening the throttle.This will enable the lubricant to reachthe correct working temperature therebyguaranteeing a correct functioning ofall engine parts.Avoid overheating the engine.IMPORTANTNever accelerate the engine after a cold start.WARNING*: Exhaust contains poisonous carbonmonoxide gas. Never run the engine in aclosed garage or in a confined area.WARNING*: This high performance motorcyclecan some times «kick back» stronglywhen you are starting it.Do not attempt to start this motorcycle unlessyou are wearing high top heavy sided ridingboots. You could seriously hurt you legif the kickstarter kicked back and your footslipped.EN31417
STOPPING THE MOTORCYCLE AND THE ENGINE- Close the throttle (1) completely so that the engine will helpslow down the motorcycle.- For normal braking, gradually apply both front and rearbrakes while down shifting (for maximum deceleration, applythe front and rear brakes firmly).- When stopped, pull the clutch lever and shift gear lever (2) inneutral position.- Press the engine stop button (3).- Close the fuel cock (4).When the bike is off, place it on its side stand.1<strong>CR</strong>32<strong>WR</strong>3418
Page 2 and 3: ENGLISH1
Page 4 and 5: IMPORTANTThe reference for recognit
Page 6 and 7: IDENTIFICATION DATAThe engine numbe
Page 8 and 9: TECHNICAL DATAENGINEType...........
Page 10 and 11: FUEL COCKCONTROLSThe cock (1) set o
Page 12: DIGITAL INSTRUMENT, WARNING LIGHTS
Page 15 and 16: HANDLEBAR COMMUTATOR (WR)The left c
Page 17: RIDINGBEFORE EVERY RIDE MAKE FOLLOW
Page 21 and 22: REPLACEMENT OF COOLING FLUIDThe coo
Page 23 and 24: CLUTCH ADJUSTMENTThe clutch is adju
Page 25 and 26: AIR FILTER CHECKTurn rear pin (1) c
Page 27 and 28: ADJUSTMENT OF THE CONTROL LEVER AND
Page 29 and 30: ADJUSTING THE SUSPENSIONS ACCORDING
Page 31 and 32: HANDLEBAR POSITION AND HEIGHT CHANG
Page 33 and 34: 2. Clean ringnut (1) and adjusting
Page 35 and 36: CHECKING THE WEAR OF CHAIN, PINION
Page 37 and 38: Removing the front wheelSet a stand
Page 39 and 40: Removing the rear wheelUnscrew the
Page 41 and 42: BRAKE PADS REMOVAL- Remove springs
Page 43 and 44: BRAKE DISC WEARMeasure the thicknes
Page 45 and 46: ELECTRICAL COMPONENTS LOCATIONThe i
Page 47 and 48: REPLACING THE NUMBER PLATE LAMP (WR
Page 49 and 50: CLEANINGIMPORTANT RECOMMENDATIONPre
Page 51 and 52: Comando acceleratoreComando acceler
Page 54: APPENDICE AAPPENDIX AAPPENDICE AANH
Page 58: A5A
Page 62 and 63: A9A
Page 64 and 65: A11A
Page 66 and 67: A13A
Page 68 and 69:
A15A
Page 70 and 71:
A17A
Page 72 and 73:
A19A
Page 74 and 75:
A21A
Page 76 and 77:
A23A
Page 78 and 79:
A25A
Page 80 and 81:
A27A
Page 82 and 83:
MEMORANDUMAA29
show all

Owner's Manual 2011 CR/WR/XC 125/150 - Husqvarna

Create successful ePaper yourself

Delete template?

Save as template?