Owner's Manual 2011 CR/WR/XC 125/150 - Husqvarna
Owner's Manual 2011 CR/WR/XC 125/150 - Husqvarna Owner's Manual 2011 CR/WR/XC 125/150 - Husqvarna
THROTTLE CONTROLThe throttle knob (1), is located on the right hand side of thehandlebar. The position of the throttle control can be adjustedby loosening the two fastenig screws .CAUTIONDo not forget to tighten the screws (A) afterthe adjustment.STEERING LOCK (WR)The motorcycle is equipped with a steering lock (1) on the R.H.side of the steering head tube.To lock it, procede as follows: turn the handlebar leftwards,place the key in lock and turn counterclockwise. Push the keyinwards (if necessary, turn to and from). Turn the key clockwiseand remove it from the lock.To unlock the steering lock, reverse the above procedure.ENFRONT BRAKE CONTROLThe brake control lever (2) is located on the right hand side ofthe handlebar. The position of the throttle control can be adjustedby loosening the two fastenig screws .CAUTIONDo not forget to tighten the screws (B) afterthe adjustment.113
HANDLEBAR COMMUTATOR (WR)The left commutator has the following controls:1) Engine stop button ( )2) HI = ( ) Selection control High beamLO = ( ) Selection control of Low beam3) TURN= Activation of left turn indicators (self cancelling)= Activation of right turn indicators (self cancelling)To deactivate the indicator, press the control lever afterits returning to center.4) HORN = ( ) Warning horn5) LIGHTS= Lighting control of lowbeams and high beam.= Lighting control of position lights.= OffENGINE STOP BUTTON (CR)On the left side of the handlebar, near the clutch control, is locatedthe engine stop button (1).CLUTCH CONTROLThe clutch lever is located on the left-hand side of the handlebarand is protected against dirt filtering in. The lever support isprovided with adjusting screw (1) to regulate clutch wire freeplay. The clutchlever can be adjusted to suit your driving position.1CAUTIONDo not forget to tighten the screws (C) afterthe adjustment.A: To decrease clearanceB: To increase clearanceREAR BRAKE CONTROLThe rear brake control (1) is placed on the right-hand side ofthe motorcycle. On models WR a stop switch, during the brakingaction, causes the rear light to come on.114
- Page 2 and 3: ENGLISH1
- Page 4 and 5: IMPORTANTThe reference for recognit
- Page 6 and 7: IDENTIFICATION DATAThe engine numbe
- Page 8 and 9: TECHNICAL DATAENGINEType...........
- Page 10 and 11: FUEL COCKCONTROLSThe cock (1) set o
- Page 12: DIGITAL INSTRUMENT, WARNING LIGHTS
- Page 17 and 18: RIDINGBEFORE EVERY RIDE MAKE FOLLOW
- Page 19 and 20: STOPPING THE MOTORCYCLE AND THE ENG
- Page 21 and 22: REPLACEMENT OF COOLING FLUIDThe coo
- Page 23 and 24: CLUTCH ADJUSTMENTThe clutch is adju
- Page 25 and 26: AIR FILTER CHECKTurn rear pin (1) c
- Page 27 and 28: ADJUSTMENT OF THE CONTROL LEVER AND
- Page 29 and 30: ADJUSTING THE SUSPENSIONS ACCORDING
- Page 31 and 32: HANDLEBAR POSITION AND HEIGHT CHANG
- Page 33 and 34: 2. Clean ringnut (1) and adjusting
- Page 35 and 36: CHECKING THE WEAR OF CHAIN, PINION
- Page 37 and 38: Removing the front wheelSet a stand
- Page 39 and 40: Removing the rear wheelUnscrew the
- Page 41 and 42: BRAKE PADS REMOVAL- Remove springs
- Page 43 and 44: BRAKE DISC WEARMeasure the thicknes
- Page 45 and 46: ELECTRICAL COMPONENTS LOCATIONThe i
- Page 47 and 48: REPLACING THE NUMBER PLATE LAMP (WR
- Page 49 and 50: CLEANINGIMPORTANT RECOMMENDATIONPre
- Page 51 and 52: Comando acceleratoreComando acceler
- Page 54: APPENDICE AAPPENDIX AAPPENDICE AANH
- Page 58: A5A
- Page 62 and 63: A9A
THROTTLE CONTROLThe throttle knob (1), is located on the right hand side of thehandlebar. The position of the throttle control can be adjustedby loosening the two fastenig screws .CAUTIONDo not forget to tighten the screws (A) afterthe adjustment.STEERING LOCK (<strong>WR</strong>)The motorcycle is equipped with a steering lock (1) on the R.H.side of the steering head tube.To lock it, procede as follows: turn the handlebar leftwards,place the key in lock and turn counterclockwise. Push the keyinwards (if necessary, turn to and from). Turn the key clockwiseand remove it from the lock.To unlock the steering lock, reverse the above procedure.ENFRONT BRAKE CONTROLThe brake control lever (2) is located on the right hand side ofthe handlebar. The position of the throttle control can be adjustedby loosening the two fastenig screws .CAUTIONDo not forget to tighten the screws (B) afterthe adjustment.113