Operation Manual - Home Mega Global Solution

HIGH ENGINE TEMPERATURE, if the module detects that the engine coolant temperature hasexceeded the high engine temperature setting level after the Safety On timer has expired, ashutdown will occur. The LCD will indicate ‘HI ENGINE TEMP’ and both the FAULT SHUTDOWN andHIGH ENGINE TEMPERATURE LED’s will flash.HIGH OIL TEMPERATURE, if the module detects that the engine oil temperature has exceeded thehigh oil temperature setting level after the Safety On timer has expired, a shutdown will occur. TheLCD will indicate ‘HI OIL TEMP’ and the FAULT SHUTDOWN LED will flash.OVERSPEED, if the engine speed exceeds the pre-set trip a shutdown is initiated. The LCD willindicate ‘OVERSPEED SHUTDOWN’ and both the FAULT SHUTDOWN and UNDER/OVERSPEEDLED’s will flash. Overspeed is not delayed, it is an immediate shutdown.UNDERSPEED, if the engine speed falls below the pre-set trip after the Safety On timer has expired,a shutdown is initiated. The LCD will indicate ‘UNDERSPEED SHUTDOWN’ and both the FAULTSHUTDOWN and UNDER/OVERSPEED LED’s will flash.GENERATOR HIGH FREQUENCY, if the module detects a generator output frequency in excess ofthe pre-set trip a shutdown is initiated. The LCD will indicate ‘GEN HI FREQ’ and the FAULTSHUTDOWN LED will flash. High frequency is not delayed, it is an immediate shutdown.GENERATOR LOW FREQUENCY, if the module detects a generator output frequency below thebelow the pre-set trip after the Safety On timer has expired, a shutdown is initiated. The LCD willindicate ‘GEN LO FREQ’ and the FAULT SHUTDOWN LED will flash.GENERATOR HIGH VOLTAGE, if the module detects a generator output voltage in excess of thepre-set trip a shutdown is initiated. The LCD will indicate ‘GEN HI VOLTS’ and both the FAULTSHUTDOWN and GEN HIGH/LOW VOLTS LED’s will flash. High voltage is not delayed, it is animmediate shutdown.GENERATOR LOW VOLTAGE, if the module detects a generator output voltage below the below thepre-set trip after the Safety On timer has expired, a shutdown is initiated. The LCD will indicate ‘GENLO VOLTS’ and both the FAULT SHUTDOWN and GEN HIGH/LOW VOLTS LED’s will flash.OIL PRESSURE SENDER OPEN CIRCUIT, if the module detects a loss of signal from the oilpressure sender (open circuit) a shutdown is initiated. The LCD will indicate ‘OIL PRESS SENDEROPEN CIRCUIT’ and the FAULT SHUTDOWN LED will flash. Sender failure is not delayed, it is animmediate shutdown.GENERATOR EARTH FAULT, if the module detects a generator earth fault current in excess of thepre-set trip a shutdown is initiated. The LCD will indicate ‘EARTH FAULT’ and the FAULTSHUTDOWN LED will flash.AUXILIARY INPUTS, if an auxiliary input has been configured as a Shutdown the appropriate LCDmessage will be displayed and the FAULT SHUTDOWN LED will illuminate.10607 OPERATING MANUAL ISSUE 1 11/27/00 MR