Quick Guide 0-10 V signal - Johnson Pump
Quick Guide 0-10 V signal - Johnson Pump
Quick Guide 0-10 V signal - Johnson Pump
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Parameter settings for Danfoss VLT ® 6000 HVAC0–<strong>10</strong>V <strong>signal</strong> from controllerTroubleshootingNot working?Parameter 620 [OPERATION MODE]/[INITIALIZE] can be used to restall parameters to the default factory settings.Procedure for intitialisation:1. Select initialisation (parameter 620)2. Press [OK]3. Disconnect mains power supply and wait for the light in thedisplay to go out4. Reconnect to mains5. Initialisation of alll parameters will be carried out6. Reprogram the above parametersWiring diagramThe connection between terminal 12 and 18 can be replaced by a contactfrom the controller.Press [DISPLAY MODE].Three values are shown at the top of the display; parameter settings008, 009 and 0<strong>10</strong>.The value on the far right is the voltage connected to terminal 53.2<strong>Johnson</strong> <strong>Pump</strong> HorticultureDe Hondert Margen 23 • 2678 AC De Lier • NETHERLANDSTelephone: +31 (0)174 51 84 <strong>10</strong> • Fax: +31 (0)174 51 84 44 • Email: johnson-pump.horticulture@spx.comwww.johnson-pump.com/horticulture
Change language