Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

2Management module diagnosticsshow logSyntax: show logThis command allows you to view the system log or the traps logged on an SNMP trap receiver, asshown in the following example, which indicates that one switchover occurred on the managementmodule in slot 9.:Brocade# show logSyslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)Buffer logging: level ACDMEINW, 24 messages loggedlevel code: A=alert C=critical D=debugging M=emergency E=errorI=informational N=notification W=warningStatic Log Buffer:Sep 28 11:31:25:A:Power Supply 1, 1st left, not installedSep 28 11:31:25:A:Power Supply 3, middle left, not installedSep 28 11:31:25:A:Power Supply 4, middle right, failedSep 28 11:31:25:A:Power Supply 5, 2nd right, not installedDynamic Log Buffer (50 lines):Sep 27 18:06:58:I:Interface ethernet6/2, state upSep 27 18:06:57:I:Interface ethernet3/2, state upSep 27 15:39:42:I:Interface ethernet3/2, state upSep 27 15:39:42:I:Interface ethernet6/2, state up...Sep 27 14:23:45:N:Module up in slot 6Sep 27 14:23:45:N:Module up in slot 3Sep 27 14:23:27:A:Management module at slot 9 state changed from standby toactiveManagement module debug commandsThere are no debug commands that are specific to management modules.Configuration notesManagement sessions can be established through the management port on the activemanagement module. If a switchover occurs, the management port on the original active moduleshuts down and all open CLI, Web management interface, and Brocade Network Advisor (BNA)sessions close. You can open new sessions with the new active module after the switchover, if thenew module has a management port.For example, if you were accessing the Web management interface using a PC connected to theoriginal active management port, you can open a new session if a PC is connected to themanagement port on the new active module. Open a new session using the same IP address youused before the switchover. (If a switchover occurs, the IP address you configured on the originalactive module is automatically assumed by the new active module.)28 Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide53-1002426-02