Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

RADIUS 9Brocade# show aaaTacacs+ key: foundryTacacs+ retries: 1Tacacs+ timeout: 15 secondsTacacs+ dead-time: 3 minutesTacacs+ Server: 207.95.6.90 Port:49:opens=6 closes=3 timeouts=3 errors=0packets in=4 packets out=4no connectionRadius key: networksRadius retries: 3Radius timeout: 3 secondsRadius dead-time: 3 minutesRadius Server: 207.95.6.90 Auth Port=1645 Acct Port=1646:opens=2 closes=1 timeouts=1 errors=0packets in=1 packets out=4no connectionshow webSyntax: show webThis command displays the privilege level of Web management interface users.Brocade# show webUser Privilege IP addressset 0 192.168.1.234RADIUS debug commandsThere are no RADIUS-specific debug commands.Configuration notes• You must deploy at least one RADIUS server in your network.• Brocade devices support authentication using up to eight RADIUS servers. The device tries touse the servers in the order you add them to the device’s configuration. If one RADIUS server isnot responding, the Brocade device tries the next one in the list.• You can select only one primary authentication method for each type of access to a device (CLIthrough Telnet, CLI Privileged EXEC and CONFIG levels). For example, you can select RADIUSas the primary authentication method for Telnet CLI access, but you cannot also selectTACACS+ authentication as the primary method for the same type of access. However, you canconfigure backup authentication methods for each access type.Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide 31353-1002426-02