Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

9802.1x“Port default MAC Filter” appears if a default MAC filter has been configured on the port. This is thefilter that will be applied to the port once the dynamically assigned MAC filter is removed. If adefault MAC filter has not been configured, the message "No Port default MAC” is displayed.When the dynamically assigned MAC address filter is removed, output resembles the followingexample.Brocade# show dot1x mac-address-filter ethernet 1/1Port 1/1 MAC Address Filter information:Port default MAC Filter :mac access-list 400 inshow dot1x ip-aclSyntax: show dot1x ip-acl [all | ethernet /]• all - Displays all dynamically applied IP ACLs active on the device.• ethernet / - Displays information for one port.This command displays information about what IP ACLs have been applied to an 802.1x-enabledport. If an IP ACL was dynamically applied by 802.1x, output from this command resembles thefollowing example.Brocade# show dot1x ip-acl ethernet 1/1Port 1/1 IP ACL information:802.1x dynamic IP ACL (user defined) in:ip access-list extended Port_1/1_E_IN inPort default IP ACL in:ip access-list 100 inNo outbound ip access-list is set“Port default IP ACL” appears if a default IP ACL has been configured on the port. This is the IP ACLthat will be applied to the port once the dynamically assigned IP ACL is removed. If a default IP ACLhas not been configured, the message “No Port default IP ACL” is displayed.When the dynamically assigned IP ACL is removed from the port, the command output shows thefollowing information.Brocade# show dot1x ip-acl ethernet 1/1Port 1/1 IP ACL information:Port default IP ACL in:ip access-list 100 inNo outbound ip access-list is setshow dot1x mac-sessionsSyntax: show dot1x mac-sessionsThis command displays information about the 802.1x MAC sessions on all ports, as shown in thefollowing example.300 Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide53-1002426-02