Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

DVMRP 8debug ip pim-dvmrp add-del-oifSyntax: [no] debug ip pim-dvmrp add-del-oif [stack]This command monitors and displays instances of multicast cache activity, such as outboundinterface (OIF) additions or deletions. When the stack option is selected, this command alsogenerates a stack trace of the add or delete event. Command output is similar to the followingexample.Brocade# debug ip pim-dvmrp add-del-oifAdded oif v10, e2/1 to (10.10.10.2, 224.225.0.1) entryThis example indicates that VLAN 10 on port e2/1 has been added to the OIF table for themulticast stream (10.10.10.2, 224.225.0.1).debug ip pim-dvmrp clearSyntax: [no] debug ip pim-dvmrp clearThis command clears all PIM-DVMRP debug settings.debug ip pim-dvmrp ipcSyntax: [no] debug ip pim-dvmrp ipcThis command displays IPC messages between the management processor and a line processor.Output is similar to the following example, which Indicates a line processor notification has beenenabled for the stream (10.10.10.1, 224.255.0.1). This stream originates from port e2/1 on VLAN10.Brocade# debug ip pim-dvmrp ipcreceive slave messages S_G_CREAT_NOTIF, entry (10.10.10.1, 224.255.0.1)intf v10,e2/1debug ip pim-dvmrp join-pruneSyntax: [no] debug ip pim-dvmrp join-pruneThis command displays information about join or prune activity. Command output resembles thefollowing example.Brocade# debug ip pim-dvmrp join-prunePIMDM:Rx Join/Prune from 30.30.30.1, on intf v10, e2/1. RPF Addr 20.20.20.1.ToME 1This example indicates that a join or prune message has been received from 30.30.30.1, onEthernet port 2/1, VLAN 10 for RPF Address 20.20.20.1. ToME means this message must beprocessed.debug ip pim-dvmrp levelSyntax: [no] debug ip pim-dvmrp level This command sets the level of detail for debug output. Levels range from 0 through 3, with 3 beingthe most detailed. The following levels are currently supported:• 0 - Receive input or send output messages• 1 - Process control messagedebug ip pim-dvmrp nbr-changeSyntax: [no] debug ip pim-dvmrp nbr-changeThis command displays information about neighbor port changes. Command output resembles thefollowing example.Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide 27353-1002426-02